TACGEAR Smock II jacket Danish M84

Product description

SMOCK II - special forces jacket The jacket is patterned according to the needs of special forces The front fastening is designed with a two-way zipper covered with a flap fastened with slotted buttons The right front part of the jacket (next to the main zipper) has a grommet opening closed with a zipper. It allows access to the internal fittings without unzipping the jacket There are 2 chest and 2 front pockets on the front. The pockets are covered by flaps with slotted buttons. Under the pockets there are other internal pockets which open with zippers. The other two pockets are on the sides of the jacket, again covered with flap pockets with slotted buttons. The two side pockets can also be opened with zippers sewn on the sides of the pockets One large (23 x 37 cm) pocket is at the bottom of the back of the jacket. The pocket can be opened with three different zippers. Two side and one top zipper, which is covered by a flap with a ribbon closure All outer pockets have vents to allow water to drain out, e.g. when wading or in the rain. The pockets and the flaps are fitted with flat ribbon closures on the upper part of the sleeve In the elbow part of the sleeve there is a pocket with a removable protector The sleeve cuff is equipped with a strap with a ribbon closure for the possibility of withdrawal The jacket is equipped with a removable hood. The inner lining of the hood is 100% nylon. The face part of the hood can be adjusted by means of a drawstring threaded through the hem and fitted with self-clips on both sides. On the front of the hood is a wide hood with a flexible wire sewn into the edge, which can be used to shape the hood as required. At the back of the hood there is a belt with a ribbon closure, which can be used to adjust the depth of the hood For better ventilation, the jacket is equipped with underarm vents, the opening of which can be regulated by pull tabs. The circumference of the lower edge of the jacket can be adjusted on both sides by tightening the drawstring secured in the desired position with self-tapping clips The jacket is not insulated, it is intended as an outer layer. For colder seasons it is suitable to combine it with other layers of clothing. Material: 50% polyester, 50% cotton RipStop (the warp of the material reinforces the fabric and prevents the spread of any tears) Weight: 1885 g (size L) This jacket can be matched with trousers in the same design.